Turns out it was caused by two mistakes:
1.) While writing the struct I overlooked a changed offset in my notes,
so a bunch of padding was missing in the middle of the struct (unk4[33]);
that padding is probably the set of colors (11) used by tail mode
2.) The LED bodies actually use RBG ordering instead of RGB
This also removes the manual addition of the universe repository, since it's already enabled in the circleci image.
Because of this, software-properties-common doesn't need to be installed anymore, and libnss-systemd isn't going to be installed (see c425780220).
However, DEBIAN_FRONTEND=noninteractive needs to be set, else the image will loop while trying to configure tzdata (aka the timezome).
Signed-off-by: Stephan Lachnit <stephanlachnit@protonmail.com>
I misread the documentation about the python3 module. The newer python
module puts the language_version in the object returned by
`pymod.find_installation()`, while the python3 module has the same
method in the *module*.
Fixes#985
This code assumes that there is a python3 or python3-embed pkg-config
file on the system, which may or may not be true. On Gentoo for example,
only python-X.Y pkg-config files are available and this will fail to
build.
This makes use of the new py_installation.dependency(embed : true) if
possible, and falls back to trying to find a python that matches the
version of python found by the python3 or python module.
libratbag has a quite communication-intensive setup routine. This patch
uses short reports when possible. Using short reports will speed up the
setup process and have a lower power consumption, which is relevant for
wireless devices.
We now check the report descriptor for the supported report IDs and
adjust the report type used based on the device capabilities. Because of
that, this patch should work without any issues as the report type will
get overwritten if it not supported.
Signed-off-by: Filipe Laíns <lains@archlinux.org>
New devices define a profile field in the button configuration. This
allows us to map a button to set the target profile as active. Even
though we don't support configuring this right now, some devices, such
as the G915/G815, come pre-configured with this action on th M-Keys.
This patch makes us able to read and write those settings, this way they
don't get lost when we write a profile to the device.
Signed-off-by: Filipe Laíns <lains@archlinux.org>
